Copy and share this link on social network or send it to your friends
CopyProduct Name | Xhorse VVDI2 V6.6.0 VVDI2 Full Version Commander Key Programmer VVDI Full Version with ID48 96Bit Copy & VAG MQB Immobilizer |
Item NO. | VVDI-Pro-02 |
Weight | 4 kg = 8.8185 lb = 141.0958 oz |
Volume | 8900 CBM |
Category | 7.Key Programmer > Xhorse VVDI |
Tag | Xhorse VVDI2 V6.6.0 VVDI2 Full Version Commander Key Programmer |
Creation Time | 2019-07-05 |
Xhorse VVDI2 V6.6.0 VVDI2 Full Version Commander Key Programmer VVDI Full Version with ID48 96Bit Copy & VAG MQB Immobilizer
Difference Among All the VVDI2 Key Programmer:
VVDI2 Full Version (SV86) | Basic+VAG (SV86-B) | Basic (SV86-C) | Basic+for BMW (SV86-D) | |
for | √ | √ | +1069USD (SV86-5) | +1069USD (SV86-5) |
for BMW | √ | × | × | √ |
for Porsche | √ | √ | × | × |
5th for AUDI Authorization | √ | √ | × | × |
for BMW OBD Authorization | √ | +549USD (SV86-3) | × | √ |
for BMW CAS4 + Authorization | √ | +199USD (SV86-4) | × | √ |
for PSA | √ | × | × | × |
for BMW FEM/BDC Functions |
have Condor (600USD) don't have Condor (800USD) |
× | × |
have Condor (600USD) don't have Condor (800USD) |
Users can refer to following information (3 steps for make keys:get key info->programming FEM/BDC system->make keys)
1.support make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)
Notes:
1.backup coding and restore coding can direct operation generally.
2.add keys, reset KM, erase key must programming FEM/BDC system first
3.in FEM/BDC interface, if 'get key info' the type not support, it will show:customer should use "for BMW E-sys software" program FEM/BDC system.then programming FEM/BDC system with VVDI2-for BMW
4.when operation on 'programming FEM/BDC system'interface,please don't close this software window until all procedures completed.
5.programming FEM/BDC system, require soldering and get eeprom.(FEM 95128 chip, BDC 95256 chip)usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6.programming FEM/BDC system,must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car,but with problem(such as the remote control cannot start the car
or the car with window problem)please use "for BMW E-sys software" coding for FEM/BDC system
7.if connect power to FEM/BDC module, but the relay keep ringing,please contact technical support for help.usually operation on FEM/BDC should be ok,just need to programming.
Copyright © 2006-2019 HULODA INC. All Rights Reserved.
No related record found